Sharp CD-BK3200V Service Manual page 19

28
MT IDLER GEAR F
LIFT GEAR A
46
10
47
11
Scale: 2 magnifications
(A)
GAP (0.3-1.5 mm)
42
45
34
36
MODE BIG GEAR
(B)
(C)
42
LIFT GEAR A
MODE BIG GEAR
37
43
38
41
LIFT GEAR B
MODE BIG GEAR
LIFT GEAR A/B/C
ASSEMBLING POSITION
< Importance >
<Assembling method of lift gear>
After setting up the mode big gear in the
shown position, engage it with the STB gear A
(gear on the lower side) at the position (A),
and assemble them, turning it in the arrow direction
into the position (B). (The short tooth directs toward the
center of the mode big gear.)
Check the gap (C) after assembly.
If no gap is found, repeat the above procedure.
43
LIFT GEAR B
41
Figure 19
– 19 –
CD-BK3200V
Mark position
(Assemble the mode big gear in this position.)
04
CHANGE BOX R
Note:
To assemble the mode
big gear, incline it,
bring it into contact with
the circumference and
put the center hole into
position since the
hatched part of the main
base is overlapped with
the circumference.
32
33
44
LIFT GEAR C
< Importance >
Direct the short tooth
toward the center.
Scale: 2 magnifications
44
LIFT GEAR C