Table of Contents
Advertisement
CD-BK3200V
LIFT GEAR A
45
46
10
47
11
Tray installing method: (After adjusting the height of the STB holder)
1. Turn the mode big gear to the mark position to lower the STB holder to
the bottom area.
2. From the front side, install the tray. (Securely insert it to the lock position.)
Measure to be taken when a disc cannot be removed due to a mechanism trouble
First, remove the mechanism unit section from the set, and check for the state of the disc.
(Remove the top plate R if necessary.)
<State of the disc>
(1) When the disc is in the normal PLAY (chucking) position → Try to eject the disc by turning the mode big gear/tray big gear
(2) When the disc is in the normal STOCK position →
(3) When the disc is not in the normal position →
In case of (1) and (2), the mechanism is normal (defective circuit parts, etc.). However, it may stop somewhere.
This is the reason why you should try to turn the tray big gear first.
In case of (3), either of the big gears does not turn.
42
41
Mark position
Be sure to assemble the tray into this position.
Insert it along the guide of
the change box.
32
33
30
35
44
40
43
40
30
35
Figure 22
manually.
* At this time, be sure to adjust the tray's position (height).
Try to eject the disc by turning the tray big gear manually.
* At this time, be sure to adjust the tray's position (height).
The tray or disc is not in the normal position.
(The tray or disc may catch somewhere.)
↓
Remove the TOP PLATE F/DISC OB lever.
Unlock the tray lock lever and pull out the tray which is not caught.
Move the caught tray or disc and remove the disc.
– 22 –
91~96
TRAY1~TRAY6
TRAY No.1~6
Rear surface: Stamped.
Note: During insertion,
Do not accidentally rearrange
tray numbers.
TRAY 6
TRAY 5
TRAY 4
TRAY 3
Rear
side
TRAY 2
TRAY 1
Advertisement
Table of Contents
