Table of Contents
Advertisement
46
10
47
11
STB HOLDER HEIGHT ADJUSTING METHOD
Adjusting procedure
1. Turn the mode big gear approx. 37 degrees in the arrow direction.
2. Viewing from the front side of the mechanism, verify that the guide ribs
(CHANGE BOX L/R and STB HOLDER)of tray are as tall as each other.
3. If they are not, bend the lever for adjustment. (Refer to the details.)
Note: Also apply the same adjustment on the R side.
When low
(Broaden the gap.)
Bend this portion to adjust the STB HOLDER
Adjustment procedure
1. Rotate the MODE BIG GEAR by 37° in the arrowed direction.
2. Check that the guide ribs (CHANGE BOX L/R and STB HOLDER) on the arrowed
TRAY are at the same height when looked from the front.
3. If they are not, bend the OS LEVER to adjust them. (Refer to the detail drawing.)
Note: Adjust the R portion in the same procedure.
42
LIFT GEAR A
45
02(102) CHANGE BOX L RIB
03(147) STB HOLDER RIB
03(147) STB HOLDER RIB
When high
(Narrow the gap.)
(121)
OS LEVER
Figure 21
41
43
04(103) CHANGE BOX R RIB
– 21 –
CD-BK3200V
80
TOP PLATE F
37°
Mark position
32
33
30
35
40
44
Advertisement
Table of Contents
