Table of Contents
Advertisement
3.3 Setting with the Engineering Tool
Check the setting of the scan talker blocks.
Open the module parameter screen of the JTNI, and select the [Talker block]
tab.
The transmission speed and information about the slot in which the output
controller using the block are displayed for the registered scan talker block.
Figure 3-20 Parameter screen of talker blocks
Download the registered data to the JTNI.
After checking the data, download it to the JTNI.
To download, display the parameter information, and select [Download (D)]
or [Download All(L)].
Restart it.
The downloaded information becomes effective at the next startup.
After the download is complete, restart it.
Unified Controller nv-pack series TC-net 100(JTNI)Extended card Instruction Manual
31
Advertisement
Table of Contents
