Huawei APM30H Installation Manual page 18

5 Installing the Cables
b
Installing the Power Cables (+
If the APM30H (+24 V DC) is not configured, skip the section.
1. Install the input power cable for the APM3
Remove the protecting cap of the power box of the
EPS48100D.
Connect the power cables. Connect the power cables
Recover the protecting cap.
2. Power cable for the junction box in
the APM30H
See "Power cable for the junction box in the TMC11H" o
page 16.
c
Installing the Power Cables (A
1 Install the input power cable for the 1. Install the input power cable for the
Remove the AC protecting cap, open the AC
Connect the power cables.
Recover the AC protecting cap, close the AC
200V Three-phase AC
mode
200V Signal-
mode
PE
Short-
circuiting
bar
Move the
short-
circuiting bar circuiting bar
L1
L2
L3
N
PE
+24 V DC)
30H
n
AC Power Supply Scenario)
APM30H APM30H
input power box.
input power box.
-phase AC
110V AC mode
L
PE
N
1 7
+
-
L1
L2
N
PE