Huawei APM30H Installation Manual page 33

10 Appendix
b
Assembling the Easy Power Rec
1. Material:
Easy Power Receptacle (Pressfit Type) C
2. Procedure for adding the contact ter
Strip the jacket off the cable according to
the scale on the equipment.
Wire of the
conductor
7.5
Ensure that the edge of the wire is not split.
Insert the conductors into the holes. That
is, insert the red cable connected to the
positive pole into hole 1 and blue cable
connected to the negative pole into hole 2.
Push back the sliding blocks until they are
in position. Then, check whether the
conductors are secure by gently pulling conductors are secure by gently pulling
the cables.
If the conductor slides outward
or the wire of the conductor is
exposed outside the hole for the conductor, remove the
conductor, cut the split wires, and then strip the jacket and
install the conductor again.
Scale
+0.5
.0
Hole for the conductor
The depth of the
conductor into the
hole should be not
less than 11 mm.
ceptacle (Pressfit Type) Connector
Connector, contact terminal, heat-shrinkable tube, and cable
rminal
Use a screwdriver to push the sliding block
until the in-position mark is completely
exposed.
The conductor should be in the
center of the holes.
The conductor should be
perpendicular to the holes.
The conductor is deviated from
the center of the hole.
3 2
In-position mark
Sliding block Sliding block
The conductor is
not perpendicular
to the hole.
The conductor is
not perpendicular not perpendicular
to the hole.