3 - 2
Startup of the printer / framegrabber
•
Plug the power connector from the monitor trolley to the power socket.
•
Switch on the system (the power switches for the framegrabber and the printer must both
be ON).
•
Wait until the framegrabber / printer has completed the startup and the printer display
shows "Ready".
•
Programming can now be carried out.
Programming
Setting the date and time
•
Check the date and time on the display of the control panel.
•
If required, press the "Menu" key on the control panel.
•
Select the "Miscellaneous" menu line with the cursor key "
"OK/Enter" key.
•
Select the "Set Date/Time" menu line with the cursor key "
"OK/Enter" key.
•
The date format, as well as the date and time, can now be changed.
•
Selected menus can be closed again with the "Erase/Cancel" key. Changes of values/
parameters previously confirmed by "OK/Enter" are taken over.
•
Press the "Menu" key to return to the main menu.
Film segmentation
•
Press the "B&W SETTINGS" key on the control panel.
•
Select the "FORMAT" menu line with the cursor key "
"OK/Enter" key.
•
Select the preferred film segmentation with the cursor key "
"OK/Enter" key.
•
Selected menus can be closed again with the "Erase/Cancel" key. Changes of values/
parameters previously confirmed by "OK/Enter" are taken over.
•
Press the "Menu" key to return to the main menu.
SIREMOBIL Compact
System Manual
SPR2-130.814.01
Rev. 01
03.01
Commissioning
↑
↓
" or "
" and press the
↑
↓
" or "
" and press the
↑
↓
" or "
" and press the
↑
↓
" or "
" and press the
Page 2 of 10
TD PS 24
3
3
3
3
Siemens AG
Medical Solutions