Setting The Video Output Resolution - LG STB-3000 Setup Manual

The first time you turn ON the STB/display panel, a Please Select Video Output Resolution menu
will be displayed, and you will need to select the appropriate option—720p, 1080p, or 1366 x 768—
for the STB's video output format. You cannot proceed with STB configuration until you make a
selection.
Note: After it is turned ON, the STB begins an initialization process, and it may take several minutes
for the Video Output Resolution menu to be displayed.
Refer to documentation for the applicable display panel(s) to determine the appropriate setting.
The selected resolution should be compatible with the display panel's native video resolution.
PLEASE SELECT VIDEO OUTPUT RESOLUTION
1. Use the Up/Down arrows on the Installer Remote to select the appropriate video output
resolution option, and then press OK.
The STB's default video output resolution is 720p. If you select this option, the Please Select
Video Output Resolution menu will close and the EZ-Manager Wizard Welcome screen will be
displayed (see pages 16 to 25 for information on the EZ-Manager Wizard). Proceed with
Commercial Mode setup as required.
If you select one of the other two resolution options (1366 x 768 is selected/highlighted as the
recommended resolution), a Changing Video Output Resolution message will be displayed, and
the STB will reboot within a few seconds to change the resolution per your selection. Continue
with step 2.
2. When the STB reboot is complete (it may take a few minutes), you will be prompted to confirm
the new video output resolution. Use the arrow keys on the Installer Remote to select YES in the
confirmation screen, and then press OK on the Installer Remote.
Note: If there is no user interaction within 10 seconds, or if you select "NO" in the confirmation
screen, the STB will reboot and revert to the default resolution. After this reboot is complete, the
Please Select Video Output Resolution menu will be redisplayed.
Once you select and confirm the video output resolution, the EZ-Manager Wizard will be displayed.
Proceed with Commercial Mode setup as required.
Note: If required at a later time, you can also change the video output resolution in the STB
Installer Menu (item 105 VID OUT FORMAT) or via USB memory device / TLX file. In either case,
the STB will need to reboot (see item 105 description on page 38 for additional information).
206-4272
720p
1080p
1366 x 768

Setting the Video Output Resolution

15