Ip Environment Setup; Accessing The Ip Environment Menu; Pro:centric Setup - LG STB-3000 Setup Manual

Hd commercial interface set-top box

Hide thumbs Also See for STB-3000:

Owner's manual (20 pages)

Owner's manual (23 pages)

Table Of Contents

Table of Contents

The IP Environment Menu enables you to set up the network features of the STB. If you intend to

create a Master STB Setup for cloning purposes (see Master STB Setup procedure on pages 40 to

42), all IP Environment settings, with the exception of Wired Network Connection settings, the STB

name (editable in the Media Share Menu), and SoftAP settings, may be cloned.

Note: With the exception of Network Setting configuration, the IP Environment settings are editable

(with the Installer Remote) only if the STB is in Pass-through Mode and read-only when the STB is

not in Pass-through Mode.

Accessing the IP Environment Menu

Note: When you enter the IP Environment Menu, the Installer Menu is exited (all current settings

are saved automatically upon exit). If you are also in the process of updating Installer Menu items,

you may wish to set all items as needed before you access the IP Environment Menu. Otherwise,

after exiting the IP Environment Menu, you will need to reaccess the Installer Menu to set additional

items.

1. Use the Installer Remote to access the Installer Menu (see "Accessing the Installer Menu" on page

30 for further information).

2. Navigate to Installer Menu item 119 DATA CHANNEL, and press 2-5-3 + MENU to launch the IP

Environment Menu.

Use the Up/Down arrow keys on the Installer Remote to select the desired menu option and then

press OK. Refer to the following sections for information on each of the IP Environment setup options.

When you have completed your IP Environment configuration as required, press EXIT or

the Installer Remote to exit the IP Environment Menu.

Pro:Centric Setup

Pro:Centric options enable you to configure the STB with the

appropriate settings to connect to the Pro:Centric server. Use the Up/

Down arrow keys on the Installer Remote to navigate between fields.

1. With the IP Environment Menu on display, use the arrow keys

on the Installer Remote to select the Pro:Centric menu option.

Then, press OK.

2. Refer to the appropriate subsection(s) below to configure the

STB's Pro:Centric settings to match those of the Pro:Centric

server.

While the Pro:Centric application (Mode) itself is an additional

feature, the appropriate Pro:Centric server configuration must be

completed to enable E-Z Installation (configuration and software/

firmware) data downloads and, if configured, the Pro:Centric

application download.

Note: By default, the Pro:Centric Menu initially shows RF

configuration fields. When you select "IP" as the Media Type, the

Data Channel field is replaced with IP Address and Port Number

fields.

206-4272