Locating The Fuses - Toro LT-F3000 Operator's Manual

bracket to the beam bracket with a latch pin and
hairpin.
1. Latch pins
2. Cab-frame flange
8. Rotate the cab support bracket toward the cab
so that it aligns between the cab-frame flanges,
and rests against the back of the cab frame
(Figure 23).
9. Insert the other latch pin through the holes in the
cab-frame flange, and secure the latch pin to the
flanges with the hairpin
Lowering the Cab
1. Remove the 2 hairpins and latch pins that
secure the cab support bracket to the cab and
the cross-beam bracket, and remove the cab
support.
2. At either sides of the cab, slowly pull down the
grab handle on the rear corner post until the cab
is fully lowered.
3. Align the holes in the cab-frame flange and the
holes in the cross-beam bracket
1. Latch pin —rotated upward (vertical)
Figure 23
3. Cab support bracket
4. Cross-beam bracket
(Figure 23).
(Figure
Figure 24
4. Insert the 2 latch pins
holes in the cab-frame flanges and cross-beam
brackets.
Note:
move the handles of the latch pins back and
forth to help align the pins to the flange holes
and beam bracket holes.
5. Rotate the latch-pin handles horizontal
25), and secure the latch pins with the 2 hairpins.
g347419
1. Latch-pin handle—rotated downward (horizontal)
6. Stow the cab-support bracket in the storage
compartment.

Locating the Fuses

The cab fuses are located in the fuse box in the cab
headliner (Figure
24).
1. Cab fuse box
Note:
The fuse identification numbers are molded
into the fuse-box cover.
g347806
14
(Figure
If the latch pins are difficult to insert,
Figure 25
26).
Figure 26
24) through the
(Figure
g018408
g036558