Locating The Fuses - Toro Greensmaster 3150 Operator's Manual

WARNING
Incorrect battery cable routing could
damage the tractor and cables, causing
sparks. Sparks can cause the battery
gasses to explode, resulting in personal
injury.
Always disconnect the negative (black)
battery cable before disconnecting the
positive (red) cable.
2. Remove the fasteners and battery clamp and
lift out the battery.
3. Connect a 2 to 4 A battery charger to the battery
posts. Charge the battery for at least 2 hours at
4 A or for at least 4 hours at 2 A until the specific
gravity is 1.250 or higher and the temperature is
at least 16°C (60°F) with all cells gassing freely.
WARNING
Charging the battery produces gasses
that can explode.
Never smoke near the battery and keep
sparks and flames away from the battery.
Important:
If you do not charge the battery
for at least the time specified above, you may
reduce the life of the battery.
4. When the battery is charged, disconnect the
charger from the electrical outlet and battery
posts.
5. Place the battery on the battery tray and secure
it with the battery clamp and fasteners removed
previously.
6. Install the positive cable (red) to the positive (+)
terminal and then the negative cable (black)
to the negative (–) terminal of the battery
(Figure 44) and secure them with the previously
removed bolts and nuts. Slide the rubber boot
over the positive terminal to prevent a possible
short from occurring.
WARNING
Incorrect battery cable routing could
damage the tractor and cables, causing
sparks. Sparks can cause the battery
gasses to explode, resulting in personal
injury.
Always connect the positive (red) battery
cable before connecting the negative
(black) cable.

Locating the Fuses

The fuses in the electrical system of the machine are
located under the seat
1. Fuses
36
(Figure 45).
Figure 45
g005523