Specifications; Attachments/Accessories; Operation; Using The Sunshade - Toro LT-F3000 Operator's Manual

Specifications

Note:
Specifications and design are subject to
change without notice.
AIR CONDITIONER
Cooling performance
Refrigerant
Recommended quantity of refrigerant
Evaporator—volumetric air flow of the blower
ELECTRICAL
Operating voltage
Fuse for radial blower / compressor
Fuse for axial blower
COMPRESSOR
Designation
Direction of rotation (viewing the pulley)
Operating speed
Piston displacement
Pressure-side connection
Suction-side connection
Magnetic clutch operating voltage
Magnetic clutch power consumption
Refrigerant oil
Refrigerant oil volume in compressor
Refrigerant oil—additional required to fill
air-conditioner system
Power consumption of air-conditioner system

Attachments/Accessories

A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
authorized Toro distributor or go to
a list of all approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.

Operation

Note:
machine from the normal operating position.
4.2 kW

Using the Sunshade

R134A
Rotate the sunshade up or down
850 g (1.87
the position of the shade.
lb)
660 m 3 /h
(23,307
ft 3 /h)
12 V
15 A
25 A
TM-08 HS
clockwise
700 to 6000
rpm
82
cm 3 /rev (5
inch 3 /rev)
3/4 inch
O-ring
7/8 inch
O-ring
12 V
Using the Air Conditioner
0.45 W
for the First Time
ZXL 100
PAG
150 cm 3
(9.15 inch 3 )
25 cm 3
(1.53 inch 3 )
2.5 kW
www.Toro.com for
7
Determine the left and right sides of the
Figure 9
1. Start the engine.
2. Switch on the blower switch
3. Switch on the air-conditioning switch
4. Set the temperature controller
maximum Cold setting (full clockwise direction).
Note:
After 3 minutes, the air-outlet louvers
should emit cold air.
5. Adjust the fan speed and temperature control to
achieve the required amount of cooling.
(Figure 9) to adjust
g347537
(Figure 4).
(Figure 4).
(Figure 4) to the