2
Symptom
Document
Interface cable
or
Operator panel
CHECK
Turn the power off and on to check if read
processing starts.
When read processing does not start, contact a
manufacturer's authorized service center.
5-6
Read processing does not start.
Are the documents loaded
properly? (Straight edge,
no dogear, no bend
corners, staples)
YES
Is the interface cable
connected properly?
Or is the baud rate
correct?
(Video, RS-232C, or
SCSI interfaces)
YES
Does the CHECK lamp
blink?
NO
Operator panel
NO
Load the documents properly.
(See p1-5)
NO
Connect the interface cable
properly.
Or set the correct baud rate.
YES
Messages and Actions
(See p5-13)
POWER