Fujitsu ScanSnap FI-5110C Operator's Manual page 74

CONTENTS CONTENTS
INTRODUCTION
1 NAMES AND FUNCTIONS OF PARTS
2 BASIC SCANNER OPERATIONS
3 SCANNING VARIOUS TYPES OF
DOCUMENTS
4 DAILY CARE
4.1 Cleaning Materials
4.2 Cleaning the Scanner Exterior
4.3 Cleaning the Inside of the Scanner
5 REPLACING CONSUMABLES
6 TROUBLESHOOTING
7 DOCUMENT SPECIFICATIONS FOR ADF
8 OPTIONS
9 SCANNER SPECIFICATIONS
Appendix
4.3 Cleaning the Inside of the Scanner
Clean inside of the scanner with a cloth moistened with Cleaner F1.
In an alternating succession of scanning documents, the accumulated paper-powder and dust inside the
scanner causes a scanning error.
As a guideline, clean the ADF every 1,000 scans. Note that this guideline varies according to the type of the
documents you are scanning. For example, the ADF must be cleaned more frequently when scanning
documents on that the toner has not been sufficiently fixed on.
Clean the ADF according to the following procedure referring to the illustrations on the following page.
CAUTION
The glass surface inside the ADF becomes hot during the scanner operation.
Before you start to clean the inside of the scanner, disconnect the AC adapter
from the outlet and wait at least 15 minutes to let the scanner cool down.
ATTENTION
Do not use water or neutral detergent to clean the inside of the scanner.
Do not use aerosol sprays to clean the scanner.
Aerosol sprays cause dirt and dust to enter the scanner, resulting scanner
failure and malfunction.
2 3 4 5
1
2 3 4 5
1