To Stop The Operation; For Timer Operation - Panasonic MLS-3751 Operating Instructions Manual

How to Use

To stop the operation

1) Press the button.
・
The product is in standby status.
2) Check the following points before opening the cover.
・
Pressure is lowered to 0 MPa.
・
COVER LOCK lamp goes out.
When the COVER LOCK lamp is lit, the temperature or pressure
inside the chamber rises to make it impossible to pull the movable
handle toward you.Sterilization objects, wear heat-resistant leather
gloves for prevention of scald.
To open the cover immediately
・
Lower the pressure and temperature inside the chamber
forcibly in the procedure as follows:
If liquid boils over in liquid sterilization, clean the inside of
the chamber.
Inside of the chamber :
1) Press the button while pressing the
2) To stop the exhaust, press the
3) Check the following points before opening the cover.
・
Pressure is lowered to 0 MPa.
・
COVER LOCK lamp goes out.
When the COVER LOCK lamp is lit, the temperature or pressure
inside the chamber rises to make it impossible to pull the
movable handle toward you.
Use care not to scald yourself when taking out the sterilized
objects at the end of operation.
Be sure to wear thermally insulated leather gloves.
Note that it takes time until liquid is cooled down.
Handling a sterilized object with bare bands immediately
after the end of operation may result in burns.

For timer operation

The operation can be programmed up to at 23:59 of 7 days later from
the current date and time.
1) Press the button.
The lamp above the timer button lights up
and the timer lamp on the digital
display Ⅱ lights up, and the current date
and time flicker.
2) Press the and
and press the button.
・
The figures change quickly when the
pressed.
・ The time on the digital display Ⅰ flickers.
24
Beep
See page 26.
button.
button again.
CAUTION
buttons to set the operation starting day
or button is kept
( Continued )
Lamp goes out.