6
Installing the Whip Guides
Parts needed for this procedure:
2
Whip guide
2
Whip guide bracket
2
U-bolt
4
Hex-head bolt (5/16 x 1 inch)
4
Flange nut (3/8 inch)
4
Flange nut (5/16 inch)
Procedure
Use 4 bolts (5/16 x 1 inch), 4 flange nuts (5/16 inch),
2 U-bolts, 4 flange nuts (3/8 inch), and 2 whip guide
brackets to install the whip guides to the caster arms
(right side shown in
Figure 17
Figure 17
1. Whip guide
2. Flange nut (3/8 inch)
3. Whip guide bracket
and
Figure
18).
g367852
4. Flange nut (5/16 inch)
5. Hex-head bolt (5/16 x 1
inch)
6. U-bolt
1. 2.5 cm (1 inch)
7
Greasing the Machine
No Parts Required
Procedure
To ensure proper lubricating characteristics, apply
grease to the machine before operation; refer to
Lubricating the Blower (page
Important:
Failure to properly grease the
machine will result in premature failure of critical
parts.
11
Figure 18
15).
g367853