Table of Contents
Advertisement
SD-10
User's Guide
E
Screen
F
Reset button
G
Strap hole
H
Strap
I
Back button
J
USB port
K
Sensor cover
L
Sensor
Understanding the Status of Color Measurement from
the Light and Buzzer
Also check the messages displayed on the screen.
Light Status
Color
Lighting
Status
White
On
Flashing
Orange
On
Blue
On
Blue or white
Brightening/
dimming
Basic Information Regarding the Spectrophotometer
Displays color measurement results, menu items, error messages, and
instructions.
Turns off the spectrophotometer and resets it. Press this button if the device stops
operating normally.
Attach the strap here to prevent the device from falling.
A strap to prevent the device from falling.
Displays the menu screen or returns you to the previous screen.
Connect the supplied USB cable to this port to supply power or charge the device,
send color measurement results to a computer application, or update the
firmware.
Open this before starting color measurement. The inside of the sensor cover is
inlaid with a white tile for calibration.
Keep this closed when it is not in use to protect the sensor. Make sure you regularly
clean the sensor area to remove any dust or other materials.
"Cleaning the Sensor" on page 35
U
Place this surface at the center of the item to be measured.
Buzzer Sound
-
-
Two beeps
Multiple beeps
-
One short beep
Two short beeps
Two beeps
-
Status
Charging. (While the device is off)
Charging has been paused because the temperature of the device
is too high or too low.
Calibration failed.
Error has occurred. Check the message on the screen.
Ready to perform color measurements.
Color measurements starts. (Comparison (Scan) mode)
Color measurement is complete. (Spot mode/Comparison (Spot)
mode)
Color measurement is complete. (Comparison (Scan) mode)
The color difference is beyond the acceptable range.
The device is in sleep (power saving) mode.
Blue: Not charging.
White: Charging.
13
Advertisement
Table of Contents
