Clutch Inspection - Polaris RZR PRO XP 2020 Service Manual

PVT SYSTEM

CLUTCH INSPECTION

NOTICE
Remove cover, spring and spider following instructions
for drive clutch disassembly, then proceed as follows:
1. Remove the clutch spacer
e
needle bearing from the Sheave assembly
2. Verify there are no binding or rough spots on the
bearing. If problems are noted, replace bearing
y
and washers . Refer to Bushing Service page 6.16.
6.14
q w r
, washers and , and
t
.
u
3. Inspect the moveable clutch sheave
wear.
4. Inspect surface of shaft for pitting, grooves or
damage. Measure the outside diameter and compare
to specifications. Replace the drive clutch assembly if
shaft is worn or damaged.
MEASUREMENT
Shaft Diameter:1.416" (35.975 mm)
Service Limit:1.413" (35.913 mm)
5. Visually inspect Vespel® thrust washers for damage.
Measure the thickness and compare to specification.
Replace if worn or damaged.
MEASUREMENT
Thrust Washer Thickness:
Standard: 0.030 – 0.040" (0.76 - 0.96 mm)
Service Limit: 0.020" (0.50 mm)
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
i
for damage or
© Copyright Polaris Industries Inc.