Switches / Controls; Ignition / Key Switch - Polaris RZR PRO XP 2020 Service Manual

Hide thumbs Also See for RZR PRO XP 2020:

Table of Contents

SWITCHES / CONTROLS

HEADLAMP SWITCH

1. Disconnect the headlamp switch harness by

depressing the connector locks and pulling on the

connector. Do not pull on the wiring.

2. Test between the 3 sets of outputs (OFF / LOW /

HIGH). If any of the tests fail, replace headlamp

switch assembly.

• Move the switch to HIGH. There should be continuity

between switch pins 2 and 3; 5 and 6; 7 and 8.

• Move the switch to LOW. There should be continuity

between switch pins 2 and 3; 4 and 5; 7 and 8..

• Move the switch to OFF. There should be continuity

between switch pins 1 and 2; 4 and 5; 7 and 8.

Pins 7 and 8 provide power and ground to light the

switch lamp.

1. Disconnect the key switch harness by depressing the

connector lock and pulling on the connector. Do not

pull on the wiring.

2. Test between the 4 sets of outputs (OFF / ACCY / ON

/ START). If any of the tests fail, replace ignition

switch assembly.

• In the OFF position, there should be no continuity

between any of the pins.

• Turn the key to ACCY position. There should be

contunity between switch pins A and B.

• Turn the key to ON position. There should be

continuity between switch pins A, B and D.

• Turn the key to START position. There should be

continuity between all the pins on the switch.

9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual

Table of Contents