Step 1. Connect The Power; Step 2. Connect To The Internet - Dell EMC SD-WAN Edge 3000 Series Activation Manual

Step 1. Connect the power

Connect the power adapter to an AC power outlet. Connect the other end of the power adapter to the power port on the
SD-WAN Edge 3800 system. When the SD-WAN Edge 3800 system powers ON, verify that the status LED on the front of the
SD-WAN Edge 3800 system is illuminated.

Step 2. Connect to the Internet

Connect an Ethernet cable to an available Internet connection, and then connect the cable to one of the four ports labeled GE3,
GE4, GE5, GE6, or any SFP+ port.
NOTE: The SD-WAN Edge 3800 system is configured by default to acquire a DHCP IP address from the ISP on the WAN
(uplink). When the WAN connection is fully operational, the LED on the front of the SD-WAN Edge 3800 is green. To use a
static IP address, see the Setting up a static IP address section.
Step 3. Follow email instructions
NOTE: If you received an email from your IT administrator, follow the instructions in the email to complete the activation
of the SD-WAN Edge 3800. If you did not receive an email, request the setup instructions from your IT administrator or
contact your Dell Technologies sales representative.
Step 4. Connect local devices
Connect the local devices such as desktops, phones, or switches to any of the LAN ports.
3