Advertisement
８．Set example of parameter
8-1．Flow of parameter set
Parameter should set according to the flow as shown hereunder.
Measure
window
※ In case setting up value over input range exceeding specification, setup value
of parameter will indicate 「Ｅｒｒ」on indication L E D, let you know setup value
is wrong and do not accept next operation.
※ In this case, please change to correct set value again.
8-2．Example of parameter set
Following is a set example to set integral time at 15 second.
（Providing that set value was 0 second before change.）
(1) Push ＭＯＤ button 1 time・・・・・・・・・・move to parameter window and LED(orange).
(2) Push ＳＥＬ button ５ times・・・・・・・・ LED（orange）lit goes down in turn
and INTEGRATION TIME LED will light.
(3) By using both → button and ↑button,
set Indication ＬＥＤ at「１５」.
(4) Push ＭＯＤ button１ time・・・・・・・・・return to measure window and start measure
again at integral１５ second.
You operate other parameters with same procedure, please.
In case setting other parameters continuously, at (4) above instead of ＭＯＤ you push
ＳＥＬ and can perform both setting parameter and moving to plural items at the same time.
Reference： Parameter and light up of corresponding ＬＥＤ
RANGE : only RANGE LED light up
L1 ON ： only L1 ON LED light up
L1 OFF ： only L1 OFF LED light up
L2 ON ： only L2 ON LED light up
L2 OFF ： only L2 OFF LED light up
INTEGRATION TIME ： only INTEGRATION TIME LED light up
９．Maintenance
Measure probe should regularly be wiped and cleaned with dry rag.
You please keep it cleaned once in every 3 months but more often because of changing media
or measure environment, you see.
When cleaning, you please switch off power.
Temperature of pipe may be high and dust monitor might be heated accordingly.
Be careful! Or you might get your hands burned.
Caution: The earth line should not be removed even at the maintenance in case
!
it may cause a fault.
Parameter mode
MOD button
Press down
(to parameter
mode）
Push down MOD button
(after parameter set, to measure
window）
Parameter select
SEL button
Push down
Respective
parameter select
written Range on the left will light on.
- 11 -
Value set
→ Move beam by
button
↑ Each button
push down change
value
SEL button push down
（after set parameter move
to other parameter item）
Advertisement
