Advertisement
５．How to connect
②
②
①
Fig.6. Removing cover
Mtg.Hole
Mtg.Hole
Fig.7. Joining screws of terminal and main block part
Fig.8. Terminal part
Attaching Screw Cover
Attaching Screw Cover
Upper：Main block part
Lower：Terminal block part
Mtg.Hole
Joining
Screws
Mtg.Hole
Power terminal
Board(Terminal)
DC4-20m terminal
Connector
(main block part)
Relay terminal
Sensor terminal
There are Attaching Screw Covers at upper and lower
portions of a surface of a Transducer.
Please remove the covers with a negative driver or the
like.
Please keep the covers which you removed.
Please attach the cover which you kept after wiring.
A terminal block part is joined to a main block part
with four points of screws and connectors.
You can see a screw joining to the terminal block part
under holes for Transducer attaching when you remove
the attaching screw covers.
Please loosen these joining screws of the
terminal block part with a Phillips driver.
You can see the terminal block of the Transducer when
you remove the main block part from the terminal block
part after having loosened these Joining Screws.
When you wire the terminal block of the converter, you
must not make any false wiring.
After wiring, please attach the main block part with
the procedure the reverse of how to remove the main
block part.
- 6 -
Advertisement
