Lenovo ThinkSystem SR550 Maintenance Manual page 123

Figure 90. Installing a PCIe adapter on the system board
Step 4. Pivot the PCIe adapter retention latch to the closed position to secure the PCIe adapter in position.
Step 5. Depending on the type of the PCIe adapter, you might need to connect any required cables. Refer
to the documentation that comes with the PCIe adapter for specific information.
Complete the parts replacement. See "Completing the parts replacement" on page 164.
Install a PCIe adapter on the riser assembly
Use this information to install a PCIe adapter on the riser assembly.
"Read the
installation
Guidelines" on
page 53
Before installing a PCIe adapter on the riser assembly, touch the static-protective package that contains the
new PCIe adapter to any unpainted surface on the outside of the server. Then, take the new PCIe adapter out
of the package and place it on a static-protective surface.
Notes:
• Depending on the specific type, your PCIe adapter might look different from the illustration in this topic.
• Use any documentation that comes with the PCIe adapter and follow those instructions in addition to the
instructions in this topic.
To install a PCIe adapter on the riser assembly, complete the following steps:
Watch the procedure
A video of this procedure is available at
C9jFjZnXQ6AmTXaIdX6_HJ
"Power off
the server
for this task"
on page 13
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
"ATTENTION:
Static Sensitive Device
Ground package before opening"
on page 56
.
Chapter 3 Hardware replacement procedures
115