Table of Contents
Advertisement
10
www.husqvarna-electrolux.se
5. BEFORE FIRST USE
WARNING!
Refer to Safety chapters.
5.1 Initial Cleaning
Remove all accessories and removable
shelf supports from the oven.
Refer to "Care and cleaning" chapter.
Clean the oven and the accessories
before the first use.
Put the accessories and the removable
shelf supports back to their initial
position.
5.2 Using the sensor fields
To activate the function press and hold
the selected symbol on the display for at
least 1 second.
5.3 Setting and changing the
time
The
flashes when you connect the
appliance to the electrical supply, when
there was a power cut or when the timer
is not set.
1. Press the
time.
After approximately 5 seconds, the
flashing stops and the display shows the
time of the day you set.
2. To change the time of day, press
and
starts to flash.
When the timer function is
active, you cannot change
the current time.
5.4 Preheating
Preheat the empty oven before first use.
1. Set the function
temperature.
2. Let the oven operate for 1 hour.
3. Set the function
maximum temperature.
4. Let the oven operate for 15 minutes.
or
to set the correct
at the same time until
.Set the maximum
. Set the
5. Set the function
maximum temperature.
6. Let the oven operate for 15 minutes.
7. Turn off the oven and let it cool
down.
Accessories can become hotter than
usual. The oven can emit an odour and
smoke. Make sure that the airflow in the
room is sufficient.
5.5 Opening and closing the
door with the mechanical door
lock
The mechanical door lock is activated by
default.
To open the door move the lock to the
right.
Close the door without pressing the
lever.
5.6 Deactivating the
mechanical door lock - in the
main oven
1. Press the door trim B at each side.
The seal releases.
2
B
2. Pull the door trim up and remove it.
3. Remove the lever 1, move it to the
right 2 and put it back in.
. Set the
1
Advertisement
Table of Contents
