Toro 02858 Installation Instructions Manual page 3

Installing the Rear
Traction-Manifold
Solenoids
1. At the back of the machine, remove the check
valve from port-CV of the traction manifold
(Figure 3).
1. Check valve
2. Assemble the high-pressure valve into port-CV
(Figure 4).
1. High-pressure valve
3. Torque the high-pressure valve to 110 N∙m (81
ft-lb).
4. Assemble the coil and nut onto high-pressure
valve as shown in
Figure 3
2. Port-CV (rear traction
manifold)
Figure 4
2. Port-CV (rear traction
manifold)
Figure 5.
g343945
1. Coil
2. High-pressure valve
5. Torque the nut to 8 N∙m (6 ft-lb).
6. Remove the cap from the 2-socket connector
g343934
of the machine wire harness labeled
SOLENOID
g343932
1. 2-socket
connector—machine
wire harness (labeled
REVERSE SOLENOID
3
Figure 5
3. Nut
(Figure 6).
Figure 6
2. 2-pin connector—coil
)
g343931
REVERSE
g343933