Advertisement
Preparing the Forward Traction
Manifold
Machines with the Optional Differential-Lock
Kit
1.
Unlatch and raise the operator's platform; refer
to the Operator's Manual.
2.
At the front traction manifold, remove the dust
cap from the Minimess fitting in port-TPB
23).
Figure 23
1. Dust cap
3.
Assemble the test equipment onto the Minimess
fitting
(Figure
24).
Note:
Place the test equipment at a location
so that you can lower the platform and start the
engine.
Figure 24
4.
Lower and latch the platform; refer to the
Operator's Manual.
(Figure
g344122
2. Minimess fitting
(port-TPB—front traction
manifold)
g344123
5.
Connect the battery, install the
storage compartment, and perform the
hydraulic-pressure test; refer to
Hydraulic Pressure (page
Connecting the Battery
and Installing the Storage
Compartment
Connecting the Battery
1.
Assemble the terminal of the negative battery
cable
(Figure
25) onto the negative battery post.
1. Nut (negative
battery-cable terminal)
2.
Tighten the forward nut and T-bolt
the negative battery cable terminal.
Closing the Hood
Models 31654
Close and latch the hood.
Installing the Storage
Compartment
Models 31657 and 31659
1.
Align the holes on the bottom of the storage
compartment with the holes in the chassis
brackets.
2.
Assemble the storage compartment to the
machine with the 3 knobs and 3 washers
26).
9
Testing the
10).
Figure 25
2. Negative battery post
(Figure
g344733
25) of
(Figure
Advertisement
