Troubleshooting Your Single Serve Brewer - Frigidaire ECMK205 Use & Care Manual

TROUBLESHOOTING YOUR SINGLE SERVE BREWER

Beyond these recommended cleaning and maintenance procedures this
Brewer is not user serviceable, for service please refer to the Warranty
section in this guide.
PROBLEM
Brewer does not have power
Reservoir rattling
Brewer will not brew Brewer
will not heating up
Brewing a partial cup
Water in reservoir base
Coffee drops around the
brewer hold when brewing
The on/off button is flashing
Water spitting from the outlet
of the brewer head.
CAUSE
Check to be sure that it is
plugged in securely.
Check to be sure that the
reservoir is well put on the
brwer
1) No water in the reservoir.
2) The brew head hasn't been
closed
1) K-Cup® pack Holder may
be clogged
2) Water is not enough to
brew the selected size.
3) Calcium or scale is built up
in the brewer.
1) The reservior is not empty
before removal.
1) Ground coffee sticked on to
the Water Outlet gasket as a
result the sealing is not good.
Temperature sensor does not
work properly.
1) The brewing is stopped
manually.
2) The handle or brewer head
is lift while the button is
flashing
SOLUTION
Plug into a different outlet.
Put the reservoir on the brewer
perfectly.
1)Check to make sure there is
water in the reservoir
2)Close the brew head
NOTE: The Brew NOW Button
will flash if the brew head is open
1) Clean K-Cup® pack Holder if
necessary and rinse under faucet
2) Make sure there is
enough water in the reservoir to
brew the selected serving size
3) De-scale the Brewer
1) Remove the water reservoir,
Turn off the brewer with the
on/offbutton, press the on/off
button and keep it pressed for 3
seconds, the pump starts to drain
the water of the base.
2) Use a dry sponge to absorb the
water if any.
Pull off the gasket gently and
rinse the gasket with water, put it
back gently after rinse.
Call service line.
1) Leave the brewer to escape
steam/residual water
completely, in 20 seconds from
the brewing process is
interrupted.
13