Table of Contents
Advertisement
Running the SETUP Program
Be sure to run SETUP the first time you use your computer, so
you can verify or update the configuration information. You
also may need to run SETUP again later if you change your
configuration.
SETUP lets you verify or change the following:
System settings such as date, time, diskette drive type(s),
and video display type
features for optimizing system performance
Green PC options, such as the time intervals before the
system and the hard disk drive go into low-power standby
mode.
SETUP also allows you to see summary information about your
system.
The SETUP program and the factory default settings are stored
in the computer's ROM BIOS (read-only memory, basic
input/ output system). The configuration information you enter
is stored in an area of memory called CMOS RAM. This
memory is backed up by a battery, so it is not erased when you
turn off or reset the computer.
Setting Up your System
1-7
Advertisement
Table of Contents
