Connecting The Drive Cables - Epson Pollution Preventer User Manual

Connecting the Drive Cables

After you replace the bracket, you need to connect the cables
for both the hard disk drive and the diskette drive. This section
includes steps for the following procedures:
Connecting the drive ribbon cable to the system board
Connecting the cables to the hard disk drive
Reconnecting the cables to the diskette drive.
Connecting the drive cable to the system board
Follow the steps below to connect the hard drive ribbon cable
to the system board, if it is not already connected.
1. Locate the hard disk drive ribbon cable; it is a flat cable with
three connectors that came in the box with your computer.
All the connectors on this cable look the same.
system board
connector
connector for second
hard disk drive
red wire
Installing and Removing Drives
connector for first
hard disk drive
4-9