Reconnecting The Cables To The Diskette Drive - Epson Pollution Preventer User Manual

Reconnecting the Cables to the Diskette Drive

Refer to the illustration below while you follow these steps:
red wire
1. Locate the connector on the diskette drive ribbon cable.
2.
Identify pin 1 on the drive and position the connector so that
the red wire is next to pin 1. Push in the connector.
Caution
If you do not align the cable connector correctly, you
could severely damage your drive when you push it in.
3.
Locate the power supply cable with the small connector.
4.
Position the power supply connector so that the holes fit over
all the pins and the red wire on the cable aligns with pin 1
on the drive's power connector. Push in the connector.
pin
red wire
Installing and Removing Drives
4-13