KitchenAid 3KSM6583T Manual page 8

USING THE STAND MIXER
ASSEMBLING/DISASSEMBLING YOUR BOWL LIFT STAND MIXER
To attach bowl:
1. Be sure speed
control is off.
2. Place bowl lift
handle in down
position.
3. Fit bowl
supports over
locating pins.
4. Press down on back of bowl until bowl
pin snaps into spring latch.
5. Sit pouring shield* on bowl.
6. Raise bowl before mixing.
To remove bowl:
1. Place bowl lift handle in down position.
2. Grasp bowl handle and lift straight up
and off locating pins.
To raise bowl:
1. Rotate handle back and up until it
snaps into the vertical locked position.
2. Bowl must always be in raised, locked
position when mixing.
To lower bowl:
1. Rotate handle back and down.
To attach pouring shield*:
1. Turn speed control to O (off).
2. Unplug Stand Mixer or disconnect
power.
3. Attach flat beater, dough hook, or wire
whip and bowl.
4. From the front of the Stand Mixer,
slide the pouring shield over the bowl
until the shield is centred. The bottom
rim of the shield should fit within the
bowl.
To use pouring shield*:
1. For best results, rotate the shield so
the motor head covers the U-shaped
gap in the shield. The pouring
chute will be just to the right of the
attachment hub as you face the Stand
Mixer.
2. Pour the ingredients into the bowl
through the pouring chute.
NOTE: Check that bowl and pouring shield
are properly in place.
*Included with select models only. Also available as an optional accessory.
8
W11391726A.indb 8
To remove pouring shield*:
1. Turn speed control to O (off).
2. Unplug Stand Mixer or disconnect
power.
3. Lift the front of the pouring shield
clear of the bowl rim and pull forward.
4. Remove attachment and bowl.
To attach flat beater,
wire whip, or dough
hook:
1. Turn speed control
to O (off) and
unplug.
2. Raise motor head.
3. Slip beater onto beater shaft and press
upward as far as possible.
4. Turn beater to right, hooking beater
over pin on shaft.
To remove flat beater, wire whip, or
dough hook:
1. Turn speed control to O (off) and
unplug.
2. Raise motor head.
3. Press beater upward as far as possible
and turn left.
4. Pull beater from beater shaft.
To operate control speed:
1. Speed control lever should always be
set on lowest speed for starting, then
gradually moved to desired higher
speed to avoid splashing ingredients
out of bowl. See "Speed control
guide."
Overload reset button
(Model 5KPM50 only):
If the Stand Mixer is overloaded, the
overload reset button will pop out and the
Stand Mixer will shut off. Turn the speed
control lever to O (off). Wait a few minutes,
then push in the overload reset button.
Turn the speed control lever to the desired
speed and continue mixing.
9/26/2019 7:18:45 PM