Panasonic AG-RT850P Service Manual page 71

5. Keep pressing 2 stoppers on the Cassette Holder
Plate and press the Cassette Holder Plate to rear
and remove 2 screws (N).
Cassette Holder Plate
6. Remove 3 screws, then press the Earth Plate to
rear.
7. Carefully lift up the Mechanism unit.
8. Unlock 4 tabs (L) and 2 tabs (T), then lift up the
Main C.B.A and the both Rear Jack C.B.A..
8. Removal of The Rear Jack C.B.A.
1. Loosen a screw (Q) and remove 2 screws (R), then
remove the MIC & Remote Jack unit from the Main
C.B.A..
2. Remove a screw (S) and remove the Rear Jack
unit from the Main C.B.A..
3. Remove 4 screws (P) and remove the Rear Jack
C.B.A. from the Rear jack unit.
Note: Installation method of the Mechanism Unit.
● Confirm the MODE switch position as following
figure.
●Make sure fit the CYLINDER cable, Loading Motor
connector, FE Head connector, MODE switch and
Supply & Take-up Photo unit on the Main C.B.A. to
the Mechanism unit.
DIS - 3
JOINT POINT
REAR
MODE SW