Table of Contents
Advertisement
1. PG Shifter Adjustment
1.
Turn OFF power.
2.
Connect the jumper wire between TP6902 and
TP6901 on the Rear Jack C.B.A..
3.
Turn ON power.
Insert the Alignment Tape
4.
5.
Confirm the unit is in STOP mode, then press the
TRACKING
+ ,
buttons simultaneously.
6.
Place the unit into automatic adjustment mode
after the unit goes to PLAY mode.
7.
When the adjustment is completed, the unit goes
to STOP mode.
8.
When this adjustment is terminated (keep PLAY
mode), the following code appear on the FLP
display.
Ž
ç
SPEC:6.5H
0.5H(TP6905,VIDEO OUT)
CODE
CYLINDER rotation is unstable during
F1
adjustment mode.
No synchronized signal up to 5 sec during
F2
adjustment mode.
F3 Not specified for fried position of the CYLINDER.
Servo not locked up to 10 sec during
F4
adjustment mode.
Note: Do not press any key during adjustment.
2. Slow Free Run Adjustment
1.
Turn OFF power.
2.
Connect the jumper wire between TP6902 and
TP6901 on the Rear Jack C.B.A..
3.
Turn ON power.
Insert the Alignment Tape
4.
5.
Confirm the unit is in STOP mode, then press the
TRACKING
+ ,
buttons simultaneously.
6.
Place the unit into automatic adjustment mode,
after the unit goes to PLAY and STILL mode.
7.
When the adjustment is completed, the unit goes
to STOP mode.
8.
When this adjustment is terminated (keep PLAY
mode), the following code appear on the FLP
display.
Ž
ç
SPEC:539Hz
10Hz(TP6906)
CODE
F6 Not Specified.
Force to step the adjustment during
F7
adjustment mode.
-
and TIME MODE
Contents
-
and TIME MODE
Contents
¯
¥
EAD-1
Advertisement
Chapters
Table of Contents
