Table of Contents
Advertisement
C. UPPER CYLINDER ASSEMBLY
For reassembling, perform the steps in the reverse
order.
1) Install the Cylinder Retainer so that the 2 holes
on top of the cylinder retainer are at right angles.
2) Tighten the hex screw (C) while pressing
downon top of the Cylinder Retainer. (Use Hex.
Wrench 1.5 mm)
3) Install the Cylinder Rotor Unit so that the inner
hole of the Cylinder rotor Unit to the small
projection (D) on top of the Upper Cylinder.
4) Tighten 2 screws (B).
5) Install the Cylinder Stator Unit.
6) Tighten 2 screws (A).
7) Confirm the PG SHIFTER ADJUSTMENT with
the alignment tape (NTSC: VFM8080HQFP) and
adjust it if necessary.
MECHANICAL ADJUSTMENT
INFORMATION
This section contains the supplementary information of
Mechanical Adjustment Procedure for Z-Mechanisum.
Please refer to the Z-Mechanisumservice manual
(Order No. VSD9706M201, VRD9802005C2)
1. TEST POINT
INTERCHANGEABILITY
ADJUSTMENT
2. SPECIFICATION
BACK TENSION
MEC-4
TP3001
VIDEO RF SIGNAL
MAIN C.B.A.
HEAD SWITCHING
TP6905
PULSE
REAR JACK
22.5 ～ 27.5g
Advertisement
Chapters
Table of Contents
