3-9-2. Procedure of Connecting the Power Cable and Turning On the Power
1. Connect the specified power cable into the AC inlet on the rear side of the PDJ-A640.
2. Connect the power cable specified in each DECK into into the AC inlet on the rear side of the DECK.
3. Turn on the power on the rear panel of each DECK.
4. Turn on the main power switch and the ROBOT switch on the lower right of the front door.
3-9-3. Tying the Cables
The example of tying the cables when connecting one unit of the DECK is presented below.
When two DECKs or more are installed, it is similar.
n
To facilitate the cable connection and disconnection, gather the cables on both sides when tying the cables
to the pipes so that the rear panel of the DECK is fully exposed.
Harness
clampers
PDJ-A640 IM
Harness
clampers
AC Inlet
Harness
fixing pipes
3-19 (E)