Table of Contents
Advertisement
3-10. Setting the DECK
1. Turn on the DOOR OPEN switch on the control panel located on the upper right of the FRONT
DOOR to open the FRONT DOOR.
2. Turn on the STANDBY switch on the front panel of the DECK mounted on cart.
Set the toggle switch on the left to REMOTE.
3. Perform the settings 525/625 and IP address etc. of the DECK.
For the operations on the DECK, refer to the operation manual supplied with the Professional Disc
Recorder PDW-1500/PDW-HD1500/PDW-F1600 and the operating instructions supplied with the
PDW-F70/PDW-F75/PDBK-A640/PDBK-104.
4. Close the FRONT DOOR, and turn on the main power switch and the ROBOT switch on the lower
FRONT DOOR.
3-11. Setting the DECK Mounted on the PDJ-A640
3-11-1. SNo.10001 to 10008
1 PDW-1500 can be mounted.
2 PDW-F70 can be mounted.
3 When mounting the PDW-F75 :
4 When mounting the PDW-HD1500 : Upgrade the Software of Node Main, Node Sub and Robot.
5 When mounting the PDW-F1600 :
After setting 3 and 4 above, the PDW-1500/HD1500/F70/F75 can be mounted together.
After setting 3, 4 and 5 above, the PDW-1500/HD1500/F1600/F70/F75 can all be mounted together.
3 When mounting the PDW-F75 and 4 When mounting the PDW-HD1500 :
1. Version check by a test mode 35
Check the version by a test mode 35 with the control panel.
(Refer to the " Test Mode " of the maintenance manual for the operating procedure.)
CONTROL
TEST
10's digit
DOOR
OPEN
3-20 (E)
Upgrade the Software of Node Main, Node Sub and Robot.
PDW-F1600 device type registration (details shown below)
TEST-35 main screen
TEST-35
SYSTEM VERSION
CLEAR
INITIAL
RECOVER
/START
TEST-35 sub screen
EXEC-35
1's digit
EXECUTION
/CANCEL
ROBOT M Ver2.12
EMERGENCY
STOP
EXEC-35
SYSCON M Ver2.22
EXEC-35
SYSCON S Ver1.12
PDJ-A640 IM
Advertisement
Table of Contents
