Steps
1. Slide the media-card reader under the system board and align the screw hole on the media-card reader with the screw hole
on the display-assembly base.
NOTE:
Ensure that the media-card reader cable stays above the system board.
2. Connect the media-card reader cable to the system board and close the latch to secure the cable.
3. Replace the screw (M3x3.5) that secures the media-card reader to the display-assembly base.
Next steps
1. Install the
system-board
2. Install the
I/O
cover.
3. Install the
back
cover.
4. Install the stand.
5. Follow the procedure in
Power-button board
Removing the power-button board
Prerequisites
1. Follow the procedure in
2. Remove the stand.
3. Remove the
back
cover.
4. Remove the
I/O
cover.
5. Remove the
system-board
About this task
The following image indicates the location of the power-button board and provides a visual representation of the removal
procedure.
46
Removing and installing components
shield.
After working inside your
Before working inside your
shield.
computer.
computer.