Table of Contents
Advertisement
Before use
Put down the date of first
1
use on the label at the rear
on the air purifier
●
Write the date you begin using the air
purifier on the label of the main unit.
This can be used as a guide for
replacing the composite air filter and
deodrizing filter.
Remove the air intake grille, and
2
set the sensor switch.
●
The sensor switch is normally set to "Lo".
●
If you feel that the sensitivity is too low,
set it to "Hi".
While the room air is clean,
3
insert the power plug into a
wall socket.
●
The sensors record and set pollution
standard of the indoor air after the power
plug is inserted.
・
Eliminated odors from the room as such as
possible before inserting the power plug.
(Pollutant sensor characteristics page 8)
Air purifier location
●
・
Leave a distance of at least 30 cm between the air inlet and the wall or nearby furniture in order to allow
the air in the room circulates freely.
Position the air purifier at least 1 meter away from appliances such as TVs and radios.
・
・
Do not run the air purifier from the same wall socket as a TV or radio.
(Picture or sound interference may occur.)
・
If air purifier is used in the same place for a long period of time, the wall surfaces around the air purifier
may become dirty.
Removing the air intake grille
●
Pull up on the tabs (2) on the top of the
air intake grille.
Tabs (2)
Main unit label (Rear)
Replacement filter
F Y104WZ
-
Part No.
Date installed:
Replacement filter
F Y504WZ
Part No.
-
Date installed:
Sensor switch
Air intake
grille
Pollutant sensor
Power plug
Installing the air intake grille
●
Insert the protrusions (6) on the inside of the
air intake grille into the holes (6) in the main unit,
and press down securely.
Protrusions (6)
Holes (6)
Put down the date
of first use.
7
Advertisement
Table of Contents
