Adding Fuel; Changing The Tine Configuration - Toro 58604 Operator's Manual

Adding Fuel

Fuel Specifications
Type
Minimum octane rating
Ethanol
Methanol
MTBE (methyl tertiary butyl
ether)
Oil
Use only clean, fresh (no more than 30 days old), fuel
from a reputable source.
Using Stabilizer/Conditioner
Use fuel stabilizer/conditioner in the machine to keep
the fuel fresh longer when used as directed by the
fuel-stabilizer manufacturer.
Important:
Do not use fuel additives containing
methanol or ethanol.
Add the amount of fuel stabilizer/conditioner to fresh
fuel as directed by the fuel-stabilizer manufacturer.
Filling the Fuel Tank
Fill the fuel tank as shown in
Figure 17
Unleaded gasoline
87 (US) or 91 (research
octane; outside the US)
No more than 10% by volume
None
Less than 15% by volume
Do not add to the fuel
Figure 17.
g230458
Changing the Tine
Configuration
WARNING
When the outer tines are installed, operating
the machine without the side shields could
expose you or others to tine contact, causing
injury or death.
• Always install the side shields whenever
the outer tines are installed.
• Never put your hands or feet under the
machine.
1. Move the machine to a level surface, shut off the
engine, and wait for all moving parts to stop.
2. Remove the lock pins from both sides of the
machine.
1. Lock pin
2. Outer tine
3. Install the outer tines per desired configuration:
•
Wide tilling—53 cm (21 inch) width
13
Figure 18
3. Inner tine
Figure 19
g358136
g358252