Counter-rotating groomer drive system dpa cutting units for greensmaster flex 1800/2100, eflex 1800/2100, andtriflex 3300/3400 series traction unit (16 pages)
Page 1
Form No. 3389-927 Rev B Cab Kit Workman ® MD/MDE/MDX/MDXD Utility Vehicle Model No. 07320—Serial No. 315000001 and Up Installation Instructions Safety WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
Page 2
decal130-5439 130-5439 1. Read the Operator’s Manual for information on fuses. 4. Windshield spray 2. Windshield wiper (15 A) 5. Windshield wiper 3. Lights (15 A)
Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Prepare the machine. – No parts required Remove the ROPS assembly. Compression spring Install the compression spring. Floor mount Nut (3/8 inch) Bolt (3/8 x 1 inch) Bolt (5/16 inch)
Operator’s Manual. Important: For 2015 and older models, you must 4. Shut off the engine and remove the key. order the 2 compression springs (Toro Part No. 5. Disconnect the battery; refer to the Operator’s 117-4847) for installation. Manual.
Page 5
Installing the Floor Mounts Installing the Cab Frame Parts needed for this procedure: Parts needed for this procedure: Floor mount Cab frame Nut (3/8 inch) Bolts (3/8 x 7/8 inch) Bolt (3/8 x 1 inch) Bolt (3/8 x 3/4 inch) Bolt (5/16 inch) Nuts (3/8 inch) Nut (5/16 inch)
Installing the Side Panels Installing the Seat Belts Parts needed for this procedure: Parts needed for this procedure: Side-plate panels Seat-belt anchors Bolts (1/4 inch) Bolts (3/8 x 3/4 inch) Side-plate foam panel Nuts (3/8 inch) Seat belt receiver end Bolt (7/16 inch) Installing the Side-Plate Panels Nut (7/16 inch)
Page 7
5. Secure the left and right seat belt anchor to the front frame with 4 bolts (3/8 x 3/4 inch) and 4 nuts (3/8 inch) as shown in Figure g026314 Figure 10 9. Mount the receiver end of each seat belt assembly to each seat belt anchor with a bolt (7/16 inch) and nut (7/16 inch) as shown in g026308...
Page 8
Connect the ring terminal on the harness to the grounding block and insert the fuse block connector into an available fuse block connection (Figure 12). If a fuse block connection is not available, add a fuse block to the fuse block grouping. Contact your Routing the Wire Harness Authorized Service Dealer for more information.
Product Overview Controls Control Panel Windshield Wiper Switch Push the top of the switch to activate the windshield wipers (Figure 13). g026274 Figure 13 1. Windshield wiper control 2. Light switch Light Switch Push the light plate to turn on the light (Figure 13).
Page 12
The method of transmission shall be electronic transmittal. This machinery shall not be put into service until incorporated into approved Toro models as indicated on the associated Declaration of Conformity and in accordance with all instructions, whereby it can be declared in conformity with all relevant Directives.