Putting A Call On Hold - Sharp FO-3150 Operation Manual

2
If you hear a soft fax tone, wait until your fax responds (you will hear
pronounced, high-pitched tones), then hang up.
3
If the fax doesn't respond, or if the other party first talks to you and then
wants to send a fax, press
phone (only on a tone dial phone). This signals the fax to begin
reception. Hang up.
•
The above step is necessary if you have set the Fax Signal Receive setting
to NO.
•
Your fax will not accept the signal to begin reception (
document is loaded in its feeder.

Putting a call on hold

To put the other party on hold during a phone conversation, press
this is done, they cannot hear you. You can put the handset back in the cradle
without breaking the connection. When you are ready to speak with the other
party again, pick up the handset. If you did not put the handset back in the
cradle, press
Beep
Pronounced, high-pitched
tones
once and
5
HOLD
again to resume conversation.
Using TEL Mode
twice on the extension
5
HOLD
. When
) if a
61