Adjusting The Volume; Selecting A Mode - Silvercrest SBL 3 D2 Operating And Safety Instructions Manual

SilverCrest SBL 3 D2
Press and hold the
speaker. A tone sequence is output and "OFF" is shown on the
display (2).

9.2 Adjusting the volume

You can adjust the volume by briefly pressing the I◂◂ (8) or ▸▸I (4)
button. The currently set volume is shown on the display (2). An
acoustic signal sounds when the minimum or maximum volume is
reached. The speaker will always power on with the volume level
that was set when it was powered off.

9.3 Selecting a mode

You can switch through the modes by pressing the M button (9)
several times. The currently selected mode is indicated on the
30 – US-EN
button (1) for 2 seconds to switch off the
The display (2) switches off after approx. 2 minutes if
no button is pressed.