Steps
1. Press and slide the speaker in the slot on the chassis until it snaps into place.
2. Connect the speaker cable to the connector on the system board.
Next steps
1. Install the
side
cover.
2. Follow the procedure in
Power-supply unit
Removing the power-supply unit
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
NOTE:
Note the routing of all cables as you remove them so that you can route them correctly while you are replacing the
power-supply unit.
About this task
The following images indicate the location of the power-supply unit and provide a visual representation of the removal
procedure.
54
Removing and installing components
after working inside your
before working inside your
computer.
computer.