Removing Optional Vga Module - Dell OptiPlex XE4 Tower Service Manual

Steps
1. To remove the dummy metal bracket, insert a flat-head screwdriver in the hole of the bracket, push the bracket to release
the bracket, and then lift the bracket out from the system.
2. Insert the optional DisplayPort module into its slot from the inside of your computer.
3. Connect the DisplayPort module cable to the connector on the system board .
4. Replace the two (M3X3) screws to secure the optional DisplayPort module to the system.
Next steps
1. Install the front bezel.
2. Install the side cover.
3. Follow the procedure in

Removing optional VGA module

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the front bezel.
About this task
The following images indicate the location of the optional VGA module and provide a visual representation of the removal
procedure.
Steps
1. Remove the two (M3X3) screws that secure the optional VGA module to the computer chassis.
80 Removing and installing components
after working inside your
before working inside your
computer.
computer.