Table of Contents
Advertisement
22/60
Assembly
Please note:
• If a circuit consists solely
of lift transverse units, the
transverse sections are
mounted directly on the
longitudinal sections.
• For parallel transverse
sections with lift transverse
units and curves / diverters,
use the connection
bridges 3 842 998 604 or
3 842 998 605 to offset the
length.
1.
Close off open section
ends with end plates and
end caps.
2.
Mount the transverse
section or connection
bridge (for the mounting
dimensions See page 18).
Assembly tip: Insert a bolt
or screw in the support
bracket to act as a stop for
the transverse section.
3.
Only when directly
connecting a transverse
section: Install the guide
kit (A, 3 842 545 975).
Bosch Rexroth AG, MIT: HQ 5/H, HQ 5/XH, 3 842 558 544/2017-07
7.5.4
Connecting the transverse section (ST 5/XH, ST 5/H: 3 842 545 869)
ST5/XH
ST5/H
SW13
M
=25 Nm
D
1
2
Fig. 7:
Connecting the transverse section on the HQ 5 (ST 5/XH, ST 5/H: 3 842 545 869)
ST5/XH
B
)
ST5/H
A
ø8
557 617-07
Advertisement
Table of Contents
