Table of Contents
Advertisement
8/60
Safety instructions
Bosch Rexroth AG, MIT: HQ 5/H, HQ 5/XH, 3 842 558 544/2017-07
• Transporting people on the product or transported material.
• Persons climbing onto the product
– the product must not be walked on or climbed onto.
• Private use.
2.4 Personnel qualifi cations
The activities described in this document require a basic knowledge of mechanical,
electrical and pneumatic systems, as well as familiarity with the corresponding
technical terms. Additional knowledge of using lifting gear and the associated slings
is required for transporting and handling the product. To ensure safe use, these
activities should therefore only be performed by a properly qualifi ed operative, or by
an instructed person acting under the direction of such a person.
"Qualifi ed operative" means someone who can recognize possible hazards and take
the appropriate safety measures due to his technical training, his knowledge and
experience, and his knowledge of the relevant regulations. A qualifi ed operative must
comply with the relevant technical regulations and have the necessary expertise.
Bosch Rexroth offers measures to support training in specifi c areas. You can fi nd an
overview of the training content online at: http://www.boschrexroth.de/didactic
2.5 General safety instructions
• Observe the applicable regulations for accident prevention and environmental
protection.
• Observe the safety rules and regulations of the country in which the product is
being used.
• Only use Rexroth products that are in good working order.
• Heed all the notices on the product.
• Persons who assemble, operate, disassemble or maintain Rexroth products should
not be under the infl uence of alcohol, drugs or medication that may affect their
ability to react.
• Use only original accessories and spare parts from Rexroth in order to prevent
hazards to people due to unsuitable spare parts.
• Observe the technical data and ambient conditions specifi ed in the product
documentation.
• Only start up the product if it has been determined that the end product
(e.g. a machine or system) into which the Rexroth products have been installed
complies with the country-specifi c provisions, safety regulations and standards of
application.
Advertisement
Table of Contents
