Turning On/Off The Virtual Surround Sound Effect; Changing Channels; Selecting A Channel Directly; Changing Channels Sequentially - Philips 32PF1700T/96 Installation And Operation Manual

32PF1700T_96_Tuner-RC-EN.book Page 8 Thursday, April 26, 2007 5:35 PM

Turning on/off the Virtual Surround sound effect

You can press 音場效果 (Surround) on the remote control to turn on or off
the display's virtual surround sound effect.

Changing channels

Selecting a channel directly

• To select a single- or double-digit channel, press the corresponding channel
selection buttons on the remote control. For example, to select channel 8,
press 0 and 8 on the remote control within 3 seconds.
• To select a triple-digit channel, press the Triple-digit channel entry button
on the remote control followed by the rest of the digits within 3 seconds. For
example, to select channel 120, press the Triple-digit channel entry button,
and then press 2 and 0 on the remote control.

Changing channels sequentially

Press 頻道 (Channel)
sequentially cycle through your channels.

Selecting favorite channels

1. Press 喜愛頻道 (Favorite) on the remote control to display the Favorite
Channels list.
2. Press or
that channel directly.
For more information about how to set up favorite channels, please refer to
"Setting up favorite channels" on page

Returning to the previous viewed channel

You can press 返回 (Recall) on the remote control to quickly return to the
previous viewed channel.

Adjusting backlight

To adjust the intensity of your display's backlight system, press 背光調整
(Backlight) on the remote control to select a suitable level.

Displaying information

Press 資訊顯示 (Information) on the remote control to display the input
signal information. The information displayed varies according to the input
source being selected.

Using the sleep timer

The sleep timer is useful if you want the display to automatically to go into
standby mode after a set period of time.
1. Press 睡眠 (Sleep Timer) on the remote control to activate sleep timer.
2. Press the button again to set the time interval. Time is set in increments of
5 minutes, from 5 to 180 minutes.
For example, if you set the sleep timer to 30 minutes, the display will enter
standby mode after 30 minutes of time. You can check the remaining time
before expiration in the Sleep Timer item in the PREFERENCE menu (See
"Sleep Timer" on page
message will display on-screen as a reminder. You can press any button on the
remote control to reset the sleep timer and the display will remain on. To turn
off this function, set the time to 0 minute.
Using the remote control
8
or 頻道 (Channel)
to select a favorite channel, and then press OK to jump to
22.
21). 1 minute before the expiration of the set time, a
on the remote control to