Setup; Adding New Digital Channels And Radio Stations - Philips 32PF1700T/96 Installation And Operation Manual

32PF1700T_96_DTV-EN.book Page 9 Thursday, April 26, 2007 5:05 PM

Setup

Adding new digital channels and radio stations

If there are new digital channels and radio stations available in your area after
the initial installation of this tuner box, you can perform the following steps
to add them to the memory.
1. Press 數位電視 (DTV) on the remote control.
2. Press 目錄 (Menu) on the remote control to display the OSD menu.
3. Press or to select DTV, and then press
4. Press
New Digital Channels, and
then press OK.
5. A warning message displays
on-screen. Make sure that
your aerial antenna is well
connected, and then press the
Red button to continue.
6. The tuner box will start scanning available digital channels and radio
stations and save them to the memory. Please be patient as this may take
some time.
The number of channels and stations scanned and stored is dependent
upon that found in your area.
7. When scanning and storing is
complete, a message that
shows the number of new
channels and stations found
and stored will display. Press
the Red button to continue
8. The Channel List will follow. Press the Green button to close it.
to select Add
or
Add New Digital Channels
Add New Digital Channels
.
PICTURE PICTURE AD. AUDIO PREFERENCE
TV/Radio TV
TV Guide >
Channel List >
Channel Editor >
Replace Existing Digital Channels >
Add New Digital Channels
Left/Right: Select main page.
OK/Down: Enter sub menu.
Please ensure the aerial is well connected before continue.
Continue Cancel
Searching complete. 02 TV channels and 01 Radio channels added.
OK
DTV
Setup 9