LG Ipsolute LW130W-D Owner's Manual page 46

Initial Configuration and Operation
IP list
> Basic Policy: Choose the basic policy for granting access.
- Allow all: Basically the access will be granted to all
IP addresses, except for those in the IP block list by
the user.
- Deny all: Basically the access will not be granted to
any IP address except for those listed in the Access
Permission List. To active this mode, there should be
at least one or more address registered in the list.
• Save: Click here to save the change you made for the
setting.
• Add: Add an IP address to the list.
1. Press [Add] button.
2. Input the following items on the list.
- Alias: Input the name here.
- From: Insert the beginning address from which
the access control policy applies.
- To: Insert the address at the end of the
application range of the access control policy.
46
Note:
To apply your access granting policy (either blocking or
opening for them) to a range of addresses, insert the
starting address of the range as the Beginning Address
and the last one as the End Address. If you wish to add
only one address, input the same address both for the
Beginning and End addresses.
3. Click [Save] button.
4. Repeat step 1 to step 3 to add more IP addresses.
• Remove: Deletes one or more addresses from the list.
1. Select the address you wish to delete from the list.
2. Click [Remove] button to eliminate it (or them) from
the list.