Table of Contents
Advertisement
Installation instructions
Water connections
Ensure that the indoor plumbing is suitable for installing a
dishwasher. Also, we recommend that you fit a water filter at
the point the mains water enters your property so as to avoid
any damage to your machine because of any contamination
(sand, clay, rust etc.) that might be occasionally carried in
through the mains water supply or the indoor plumbing, and
to reduce the occurrance of things such as yellowing and
formation of deposits after washing. The installation shall be
in accordance with the requirements of AS/NZS 3500.1.
Water inlet hose
of 0.03 MPa to a maximum of 1 MPa. If the water pressure
is above 1 MPa, a pressure-reducing valve should be fitted
between the tap and the water inlet hose.
After the connections are made, the tap should be turned on
fully and checked for water tightness.For the safety of your
machine, make sure to always turn off the water inlet tap after
each wash programme is finished.
Use the new water inlet hose supplied
with this machine. Do not use the water
inlet hose, if any, from your old machine. If
connecting a new water inlet hose, or one
that has not been used for some time, run
water through it for a while before making
the connection. Connect the water inlet
hose directly to the water inlet tap. The
range of water pressure that the unit is
designed to operate on is from a minimum
12
Advertisement
Table of Contents
